4l80 slip yoke options

[dabeetereater]

anybody know where to get a good slip yoke, like a spicer 1350 yoke,

and a pinion yoke for a 14bolt

my truck is swaped and the driveshaft shakes so bad it keeps popping out the tail shaft seal so im gonna have a good shaft built thats not gonna break

[2boosted]

For yoke slip yoke you can use this one....http://www.apsracingusa.com/servlet/...ip-Yoke/Detail

As for the Pinion yoke, Ron have you covered :
http://www.ronsmachiningservice.net/...-GM-9.5/Detail
http://www.ronsmachiningservice.net/...-PINION/Detail

I bought most parts for my 14 bolt swap with Ron.

[dabeetereater]

thanks but any cheaper options lol, i got a 1350 slip yoke for my t56, it was a spicer, for like 70 shipped i think

[sprayedenali]

driveshaftspeacialist.com

[dabeetereater]

well got under my truck last night and its already got the 1350 slip yokes in it, measured them, so all i got to do is get the correct length diriveshaft, so that will save me some money

[farmtruc]

driveshaftspecialists is local to sa, tx, we use them for all of our driveshaft needs.
just have them build you a shaft and be done with your shaft issues.
they can make an aluminum shaft up to 5" diameter for high rpm/mph to drag racing shafts.

they understand critical speed and torque specs.

give them a call and see what they say.

[8-ball]

Moser.com

[dabeetereater]

i have a local shop here in town that makes driveshafts, iv used them before for my ls1 rx7, did a great job on it, but they dont cary much performance stuff in stock so iwas gonna try and find the parts, but according do the measurements on stuff iv found i think they are already 1350's,
and measured the driveshaft last night and its only 3/8's of a inch to short, not sure if that would make a big difference or not, might just let the one i have in the truck ride for right now for a week or 2 until i get some extra cash,