new motor spun a bearing

[TXsilverado]

so, I got the motor installed last weekend. 15k mile old LQ9 from an escalade that has been sitting up for a few years. apparently it was hurt when i got it because it spun a rod bearing within 5 miles. my #2intake valve feels like it is now kissing the piston (i JUST got these heads re-done). for the 5 miles that it ran, it was a BEAST. talking about a crappy feeling lol. i was so excited to get that motor into the truck and didnt get a chance to enjoy it. the truck is in the back yard again where it has been sitting for the last 6 months.

here is an idle clip before everything went south.
http://smg.photobucket.com/albums/v6...t=f7862026.mp4

[Ray@NP]

i know that feeling man, that suck i blew my engine too

[Show&Go]

Dude that blows! Whats the new plan? leave her down a while and 402 it? ya got a 6.0 block you can use...

[06Sierra2]

i seen this on the other site. i hate hearing about threads like this. u think mabye the bottom end just sat too long without being lubed?