ls6 cam/spring and double roller swap and upgraded oil pump and 34" hd rad upgrade w/ second 16" e fan
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
ls6 cam hot idle (800 rpm) and rev (3500 rpm)
http://s181.photobucket.com/albums/x...t=MOV01468.mp4
so i finally installed my truck dedicated wideband and what it showed my on my fist WOT 1/2 test run (short shifting) surprised me a lot. all the mods Ive done to the motor i figured i would be a little lean (around 13.2 to 13.4) so i only have been running 18 degrees timing in my high oct table and running 91 oct fuel. the only fuel side mod is different maf tables for de-screening. but in the run im very very rich for a good 75% of the time in WOT
http://s181.photobucket.com/albums/x...fbefortune.mp4
powder coated my valve covers today
installed my front brakes and lines tonight and powder coated the calipers (will do the rear tomorrow)
started doing the rear brakes to day, when i pulled off the dr side rotar i found a mess from a leaking axle shaft seal so i replaced both sides and powder coated the diff cover and both the calipers. I went to bleed them and messed the bleeder up bad trying to loosen it so i stopped for the day (will post pics tomorrow after i get 2 new bleeders)
and a pic of our local raccoon "skeeter" that i feed by hand
Last edited by beingblueeyes; 07-03-2011 at 03:15 PM.
HA i love that oil cap breather, makes it easy to take out for cleaning.
Beautiful job man, truck is awesome.
thanks man
today i installed the drop hangers, it wasn't as hard as i thought it would be. with the hangers installed it now has that nose up cali look i HATE, so im going to drop the front another 2"
nice truck dude.
Get drop spindles in front
what brand do you recommend 2boostedSilverado?Originally Posted by 2boostedSilverado
i will have my 2" drop spindles for sale in a week or so when i get them off.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
I use Mcgaughy's 33004, no problem.
Also heard good things about Belltech 2508
Both are about the same price.
Ask Mic his brand, and try to make a buy there. Usually they don't wear.
Posting Permissions
Reply With Quote
