any one know what will cause the a/c compressor to short cycle?
the compressor stays on for like 5 sec and then turns back off for bout 7 sec
02 silverado 5.3
any one know what will cause the a/c compressor to short cycle?
the compressor stays on for like 5 sec and then turns back off for bout 7 sec
02 silverado 5.3
A low charge of freon would do it.
1991 Silverado ECLB
LM7-T56
Is the air still cool? If so it's probably normal.
2006 GTO M6 Brazen Orange
2006 Silverado CCSB Duramax
2001 ECSB 4x4, 5.3, Radix, 3.0 pulley, VHP Trucker cam, 216/224 .551/.551 115 lsa, 1.8 Crane roller rockers, 4L65E, Yank SC3000, 3.73, Cal-Tracs, HPTuners.
this is the first time i have used it since the 5.3 swap. the low pressure side is fine...someone else said it was the orfice ttube...what ya'll think?
The oriface tube is basically just an inline filter, after the compressor. It should be okay unless your compressor is coming apart, filling it with metal, and plugging the line. What you described is exactly what happens when your refrigerant charge is too low.
2001 ECSB 4x4, 5.3, Radix, 3.0 pulley, VHP Trucker cam, 216/224 .551/.551 115 lsa, 1.8 Crane roller rockers, 4L65E, Yank SC3000, 3.73, Cal-Tracs, HPTuners.
k...ill double check it thanks...what should the pressure be on the low side (round about figure?)
Don't know--but you can go to your local auto parts store and buy a R134a recharge kit to where you can charge it yourself. Make sure to buy a setup with an inline pressure gauge--and follow the directions specifically.
2000 ECSB 6.0L
TORQUER V2 CAM ● COMP 918's ● 7.4 HARDENED PUSHRODS ● K&N SERIES 77 CAI ● 80mm BBK ●PACESETTER LT HEADERS AND 3'' ORY ● SUPER 40 FLOW ● 3000 STALL ● 4.10s ● BUILT 80e ● VORTEC PERFORMANCE TUNE ● MSD 8.5mm PLUG WIRES● ELEC. CUTOUT ● UD & ALT PULLEYS ● FLEX-A-LITE E-FANS ● 22" CENTERLINE STINGRAY III's ● LUND FIBERGLASS TONNEAU ● 2" LEVELING SHACKLES ● 12K HID LOWS & FOGS ● LEDs ● DEBADGED ● WHITE-FACED ESCALADE GAUGES ● KICKER 450.1 ● 2-CVR 10's ● DS60's ● K693's
my buddy is a mechanic and has all the gauges and stuff...i was just looking for a estimated number of what should be in there and ill compare that to what is in there now.
IDK about the psi...35-40psi maybe??? Also, a low charge of freon can cause the "short cycles," but typically the main cause of the short cycles with the compressor is the Pressure switch...
2000 ECSB 6.0L
TORQUER V2 CAM ● COMP 918's ● 7.4 HARDENED PUSHRODS ● K&N SERIES 77 CAI ● 80mm BBK ●PACESETTER LT HEADERS AND 3'' ORY ● SUPER 40 FLOW ● 3000 STALL ● 4.10s ● BUILT 80e ● VORTEC PERFORMANCE TUNE ● MSD 8.5mm PLUG WIRES● ELEC. CUTOUT ● UD & ALT PULLEYS ● FLEX-A-LITE E-FANS ● 22" CENTERLINE STINGRAY III's ● LUND FIBERGLASS TONNEAU ● 2" LEVELING SHACKLES ● 12K HID LOWS & FOGS ● LEDs ● DEBADGED ● WHITE-FACED ESCALADE GAUGES ● KICKER 450.1 ● 2-CVR 10's ● DS60's ● K693's