Printable View
I need help with some wires. I found two connectors that had no home hanging on the back of my harness near the passenger O2 sensor. I started pulling wires out of the harness and traced them to the C100 connector.
http://i1049.photobucket.com/albums/...ps996cf4ef.jpg
What are these and do I need them? Do I need anything for that matter that is on the C100. Here is the wires on the C100
http://i1049.photobucket.com/albums/...ps159d036e.jpg
Thanks for your help
not sure what wires are what on the 94, i have a 96 & they're different, but your speedo, tach, oil pressure, temp, check engine & a few others are in that plug & you will need to tie into them.
Thanks for the reply. Ok I figured it out after some reading and got the wires pulled and labeled. I still have a few questions now about left over wires. First 3 wires that go the connector that plugs into my tac module for drive by wire. What are these, and do I need these 3 wires?
http://i1049.photobucket.com/albums/...ps217da175.jpg
Second, I have 2 wires that go some weird connector on my negative battery cable. What's the fix for this one?
http://i1049.photobucket.com/albums/...ps45f7c8c2.jpg
Thanks for your help.
Ok that link really helped out, thanks kewljay. I discovered that those wires go to my cruise control switch.
http://i1049.photobucket.com/albums/...ps8a7997e4.jpg
Now, if anyone has information on the other 2 wires on that battery generator thingy, I would greatly appreciate it.
I can look up some info on alldata for you.
What model did this motor come from? What is the 8th vin number from donor vehicle?
Generator battery control module. That is what is around the negative battery cable.
Thanks brother, I appreciate your help. Here is the printout from the donor.
http://i1049.photobucket.com/albums/...psb7b4fa68.jpg
It's a module of some sort with a 10 pin connector
http://i1049.photobucket.com/albums/...psbc59da3b.jpg
The numbers on the top of the module read 15137027
The bottom reads RVGB 621375