Printable View
anybody know where to get a good slip yoke, like a spicer 1350 yoke,
and a pinion yoke for a 14bolt
my truck is swaped and the driveshaft shakes so bad it keeps popping out the tail shaft seal so im gonna have a good shaft built thats not gonna break
For yoke slip yoke you can use this one....http://www.apsracingusa.com/servlet/...ip-Yoke/Detail
As for the Pinion yoke, Ron have you covered :
http://www.ronsmachiningservice.net/...-GM-9.5/Detail
http://www.ronsmachiningservice.net/...-PINION/Detail
I bought most parts for my 14 bolt swap with Ron.
thanks but any cheaper options lol, i got a 1350 slip yoke for my t56, it was a spicer, for like 70 shipped i think
driveshaftspeacialist.com
well got under my truck last night and its already got the 1350 slip yokes in it, measured them, so all i got to do is get the correct length diriveshaft, so that will save me some money
driveshaftspecialists is local to sa, tx, we use them for all of our driveshaft needs.
just have them build you a shaft and be done with your shaft issues.
they can make an aluminum shaft up to 5" diameter for high rpm/mph to drag racing shafts.
they understand critical speed and torque specs.
give them a call and see what they say.
Moser.com
i have a local shop here in town that makes driveshafts, iv used them before for my ls1 rx7, did a great job on it, but they dont cary much performance stuff in stock so iwas gonna try and find the parts, but according do the measurements on stuff iv found i think they are already 1350's,
and measured the driveshaft last night and its only 3/8's of a inch to short, not sure if that would make a big difference or not, might just let the one i have in the truck ride for right now for a week or 2 until i get some extra cash,