Forum: Performance Modifications

so im new to this and trying to build my motor right. i have a 5,3 with 799 heads. im pulling the motor to put in LQ4 block bored 30 over forged...

OK here goes.. why not replace the stock 2004 gmc5.3 pump witha E85 pump to get more flow right..afterall E 85 needs more flow for given HP! ...

How do I move a thread from pics vids to here? I'm going to need technical input and suggestions in this super budget build beast lol....

I talked to arh today. They told me they didn't have headers for my 2004 2500 Silverado 4x4. They said the headers would fit but the mid pipes...

going to be getting a new motor for the truck the 5.3 is on its way out... heres what im thinking lq4. 317 heads. may have them cleaned up see...

Hey guys, about two months I purchased a 05 Silverado 1500 ext cab 4wd with the dreaded 4.8. Was kind of in a bind and needed a vehicle or I would've...

Haven't been able to find information on weather i can run E85 or not on a 2009 GMC sierra 4.8. In HP tunersit does have a section for flex fuel and...

So I am in the middle of doing a 6.0 lq4 swap into my 95 k1500 and am looking to do a cam while I have the motor out. It'll be a first as far as...

Hi Guys I have a tech ? I purchased a TCI flex-plate for my truck after i found out that my stock one is cracked. here is a few details on my...

I have a 2013 Sierra with a 4.8L. I have long tube headers ypipe back exhaust as well cold are intake and a tune right now but I want more power I...

Well I made it to the track last fall with my 6.0 obs rcsb truck ran good went 12.30 at 110 current set up is a stock lq4 with shaved .030 243 heads...

Hey everyone. I wasn't sure if this should go in the performance or conversion swap section so if this isn't where it belongs feel free to move it. ...

I keep hearing rumors that the spindle from a NBS (6-lug) can be swapped into an OBS to facilitate bigger brakes on an OBS. Cant seem to run them to...

Hey guys, just picked up a 2010 Sierra with the all aluminum flex fuel 5.3. I'm looking at doing the DOD delete and a cam with supporting mods. My...

Was thinking of using a 90mm (actually 88mm) throttle body off a newer 6.0 & 6.2 truck engine with the 4 bolt pattern but my stock intake is for the...

I bought a used 2003 Denali 6.0L LQ4 from a dismantler. I purchased a new cam from Lingenfelter. I asked them which cam would work well with a...

I'm wanting to build a decent 5.3. I've got the whole top end from a 2000 z28 I.e. heads intake fuel rail and injectors that I've thought about...

well let me give you guys a little back story, my little sister dated a guy all through high school and he had a 2002 ext cab Silverado with a 4.3....

I've been working on bolt in coil-overs for many different applications. This one is for a 99-07 with stock upper and lower control arms. This...