Forum: LSX Truck Conversions

Just did a 5.3 swap in my burb. I need the fan to be about 2"-3" closer to the radiator to get the fan around the half in half in point. I cant find...

I've been wanting to do this for some time now. I ran across a good deal on a lower mileage LQ9 a few weeks ago so I picked it up. I have big...

What mufflers do u guys run with true duals

Im putting my double springs in. The valve seals that came with my comp kit dont have the lower portion on them like the factory ones. It looks...

Im new to the form page. I have a 91 chevy 2500 light duty EXT Cab 2WD. It curently has a 5.7L TBI 350. I want to swap it out for a 6.0L iron block...

Is it that critical or is eye ball centered up good enough

I have been reading and have some useful info. But I have a few ?'s regarding what I have. I recently purchased a complete L33 and auto trans. When...

IF I was to buy a 6.2 to swap into my truck, would the year matter? I would assume it would be pretty much plug and play. And just get retuned.

Im running a 2001 silverado ls motor in my 84 and I needed help with the wiring from the a/c compressor to the original harness on my 84 C10. Anyone...

lots of time has gone into this build so far and lots left to go. I have made all of my own parts for this build. I made my own mounts, oil pan,...

Hello, I have a 03 6.0 in my 95 1/2 2wd chevy truck, the engine has a Texas Speed 224R cam, their double spring's and hardened 7.4 pushrod's, with...

deceided to put a three wire sensor in the stock location. what are the pins for that sensor? Is A and B the same and C to the gauge? Just a guess?

Swapping an LS1 from a 1998 Camaro SS into a 1993 C1500. Do I need to change the oil pan?

On my 95 the harness goes in the fire wall on both sides. I know I will have to keep it on the drivers side but after the mods to the harness will it...

Im gonna run 05 truck e fans in my blazer. Ill be running the 93 ac setup. How do i get my ls pcm to operate my efans when ac is on.

okay i have a 1990 chevorlet silverado that has an old worn out 5.7 tbi motor in it. i recently bought a 2003 5.3 motor complete with all...

What do I need to make it stand alone for my 89 k1500? Thanks for all the input guys! Have learned a lot here.

Hi, I am getting ready to drop a L9H or L96 (with VVT) into a 98 ext 5.7 2wd. Most of the hardware is well developed, with lot's of good hints on...

So I'm starting a 6.0 swap to my truck it is a 1991 4x4 k1500. I want to put long tube headers on it but Idk what brand will work with 4x4. I've been...