Forum: LSX Truck Conversions

Will exhaust manifolds off of a 5.3 work on a 6.0? Or is there some difference that wont allow a swap between the two?

I've been studying swapping a 6.0/4L80 into my 1997 RCSB 4.3 for several years. It's not my daily driver, just going to be a fun toy. I had...

Ok. So, I put my adapter plates and attach my motor mounts to my L33. As I am wrestling with it, I realize that the holes I selected arent lining up....

I'm swapping a 4.8L into a '93 Silverado. Just wondering what the best way to plum the EVAP solenoid or even if I need to. Thanks.

Ok so im swapping a 5.3 into a 89 reg cab Chevy. Can I use the factory trans? And then just tune the ecm to not need the trans?

Well, i figured since i am going to be around a while, and i like to document , i would create a build thread for this. I have decided in the...

I know this isnt the correct section but it seems to be the most viewed.. i have a small problem. I have a 2005 yukon xl Denali (parents vehicle) and...

I spent nearly 3 weeks buried in my laptop trying to put all the info together to do this swap. Although the info is all over the intrawebs, it...

Which gears do you prefer for seat of the pants feel and overall driving, I have 3:42's now and I can't decide if I like them or not, the truck runs...

Just testing the waters here for a conversion. As of now this would be going into a rcsb 4x4. What is the best and average you are getting with maybe...

I put a 5.3 in my 1992 pickup 2wd 5 speed with a stand alone harness cable driven throttlebody.Every time i start it cold or hot it will idle up to...

has any one had any problems with the headers been too close to the firewall. I have schoenfeld headers , 1'' set back motor plates . the driver...

Bought some LS1 fans and ordered Nelsons ls1 fan harness. they are tunin my ecm to turn one of the fans on "low" once it hits 180 degrees. And they...

how hard of a swap would this be, and what would i need to get it done?

Completely done with swap, only issue is AC will not work, compressor kicks on but is not cooling, only thing different with a/c system is I tied the...

hey guys, i just put a 6.0 liter in a 93 dually and was wondering if i should run the oil cooler or not.... I cant get it to work as the piping uder...

ok this is my 82 chevy swb it was my first vehicle so its special to me. im thinking i will do a swap to it of some sorts. maybe a 6.0 stoked...

Got everything finished up and ready to go get exhaust but I cannot seem to get the air out of the system, the upper hose is getting hot but the...

I just put an LM7 into my 98 K2500. The swap is going fairly well, but I had a friend come over to delete the EGR, VATS, downstream o2 sensors etc....

Been searching on here for an answer, but every build is different! I have an 88 GMC I'm converting over to a 6.0l 4l80e, what I want to know is...