LSBrackets.com AC Bracket

  1. 2 This is the hole where short bolt goes to attache the back plate.

  2. 3 The small bolt attaches the back plate to the head with the short cylinder behind it.

  3. 4 The front AC bracket plate with the two 4 inch bolts and the second largest cylinders.

  4. 8 This is the second longest bolt in the kit. It runs through both bracket plates and into the top of the head.

  5. 9 This is the longest bolt in the kit. it holds the tensioner (when I get it).

  6. 10 Obviously, the middle hole and the two on top corners of the bracket are for the three bolts that hold the compressor in.

  7. 11 The bolt sticking out is supposed to hold the new Gates #38163 Tensioner, but i haven't got it yet. This bolt is the longest in this kit.

  8. 7 This is the second longest bolt.

  9. 12 Back of the bracket with the compressor on.

  10. 6 The second longest bolt will run through both bracket sides and into the top of the block.

  11. 13 Mock-up with the compressor

  12. 1 The smallest bolt in the set goes into one of the two short, fat cylinders to get started.

  13. 14 Mock-up with a compressor in the bracket.

  14. 5 The two 4 inch bolts mount where the old tensioner went - on the top of the water pump housing.

  15. 15 for fun, I put the old air filter unit on. It obviously doesn't fit with the aftermarket AC bracket.
Showing pictures 1 to 15 of 15