98 Silverado LM7/SAS project

[iridektm]

Hey guys I have finally begun my project.

Project truck is a 98 C1500 that is getting a LM7/4L60e 4x4 combo. I am doing a SAS on the truck as well.

Parts I've gathered so far:
-LM7/4L60e w/ Tcase out of a 99 K1500 (complete donor truck). Rebuilt trans, 114k on the engine
-Programmed PCM
-Harness just got sent to Nelson this afternoon

I still need to aquire quite a bit.
-Headers
-Misc exhaust parts
-EGR Delete kit
-CAI
-Dana 50/60
-Plugs and wires
and the list goes on and on...

I worked out a deal for an entire 99 LM7 truck. I just had to make the guy a set of bumpers.



Here's the project truck.



Slight frame damage...Need to figure out how to make it match the drivers side since that is where the SAS brackets are going to be going.

Any ideas??

LT1 and LM7 hanging out


Somewhat at a standstill right now. I would like to do the axle swap before I drop the motor in for ease of install but craigslist is looking pretty slim for the past week on axles. Not to sure on the game plan at the moment.

Next step is to swipe the card and get some parts to my door.

I will keep the thread updated with progress and plenty of pictures.

Thanks for looking!