Yes the brake lights and wipers were working before. The wipers had the intermittant problem where they would turn on and not turn off right away, but they worked.
I just confirmed this morning that the following DOES WORK:
Night driving lights
Reverse Lights
Turn Signals
Brake lights DO NOT work. Third brake light also does not work but I don't remember if it worked before.
Before the swap my brake lights stopped working due to the circuit board behine the steering wheel. I replaced that circuit board and wiring harness and the brake switch on the brake pedel which fixed the problem then, so those parts are new. There is a wire somewhere that I did not hook back up is what I am thinking. Does anyone have any pictures of where in the engine bay the ground wires are and the relay? I rewired the grounds on the intake so they should be good.
1994 Silverado 2 door sport side
Soon to install:
5.3 LM7, Thumpr Cam, LS6 lifters/springs, LS1 1.7 rockers, 862 heads milled 0.015 and 45 degree cut valves, LS2 timing set, Performer RPM intake, Holley 4150 750cfm carb, MSD 6LS ignition, 2" Primary LT headers 3" X-pipe and two Loudmouth II Mufflers. Vigilante 9.5" 2,800 Stall.