+ Reply to Thread
Results 1 to 9 of 9

Thread: STS install and Code P1518 HELP!!!!!!!!

  1. 04-08-2007 04:01 AM #1
    2500HD6.0
    2500HD6.0 is offline Senior Member
    Join Date
    Apr 2005
    Posts
    202

    Angry

    Ok we got the STS installed and we where trying to check the buzzer and by just turning the key on with out starting the truck by connecting the pressure switch at the pump with a jumper cable. When we did this we blew tons of fuses the fuel pump fuse blew as we as many others. We have replaced all of them but we have not tried the buzzer (which did not work) again the oil pump is working but now I am throwing a code it is P1518 which is
    P1518 Intake Manifold Runner Control (Stuck Open)
    The truck is running and I drove it about a mile to get home and it ran fine my ? is what did we do wrong to blow tons of fuses and why do you think my truck is throwing this code.

    Is it safe to drive 7 hours because I have to get back to school Sunday night and go see Allen some time in the next week to get a tune?
    2500HD 6.0 - K&N filter, TB bypass, Ported and Polished TB, no cats, SD Tune BY Nelson, 42# injectors, STS, T-67 .96 A/R, @5psi Walbro 255lph, Air to Water Intercooler, coolingmist kit @ 6ghp
    CJ-7 - K&N, TBI 350, dana44 front locker, 9" ford rear spooled three link, 38.5" SS, bead locks,and tons more.
    http://i44.photobucket.com/albums/f4.../100_04079.jpg http://i88.photobucket.com/albums/k1...eepcroped2.jpg
    Reply With Quote Reply With Quote
  2. 04-08-2007 10:15 AM #2
    GMCwantsLS1's Avatar
    GMCwantsLS1
    GMCwantsLS1 is offline Turbo Moderator
    Send a message via AIM to GMCwantsLS1 Send a message via Yahoo to GMCwantsLS1
    Join Date
    Mar 2003
    Location
    San Marcos Texas
    Posts
    4,393
    You might go back and double check all the connections by the STS install manual. It should never blow the fuel pump fuse. The fuel pump relay should supply power to turn on one of the coils in the relay for the oil pump.
    2006 Superior Blue Trailblazer SS AWD, Stock as a rock

    Sold: 2002 GMC Sportside Denali front end with a 2002 LS1, FLT level 5, Yank 2600, Trick Turbo, T76, Nelson intercooler, 60LB injectors, Warbro fuel pump, Eaton locker, Magnaflow, 3.42, Nelson Performance Tuning (speed density).

    Sold: 1981 GMC LB RC 1500 2002 4.8L 4L60E 12 bolt 3.73 Richmond Lock Right AC PS Nelson Performance tuning
    Reply With Quote Reply With Quote
  3. 04-08-2007 10:56 AM #3
    RedHeartbeat
    RedHeartbeat is offline WTH JUST HAPPENED?
    Join Date
    Nov 2003
    Location
    Denton Texas
    Posts
    20,540
    Since he has a NA tune shouldnt he be able to just run the stock air intake if he caps off the boost tube(to keep from over-reving the turbo)? I'd be afraid of blowing the engine with any kind of boost on a stock tune.
    See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
    Reply With Quote Reply With Quote
  4. 04-08-2007 11:59 AM #4
    GMCwantsLS1's Avatar
    GMCwantsLS1
    GMCwantsLS1 is offline Turbo Moderator
    Send a message via AIM to GMCwantsLS1 Send a message via Yahoo to GMCwantsLS1
    Join Date
    Mar 2003
    Location
    San Marcos Texas
    Posts
    4,393
    I've seen before if a clamp is loose or not there it will not make even 1 psi of boost. You should not try to make boost so as not to over spin the turbo.
    2006 Superior Blue Trailblazer SS AWD, Stock as a rock

    Sold: 2002 GMC Sportside Denali front end with a 2002 LS1, FLT level 5, Yank 2600, Trick Turbo, T76, Nelson intercooler, 60LB injectors, Warbro fuel pump, Eaton locker, Magnaflow, 3.42, Nelson Performance Tuning (speed density).

    Sold: 1981 GMC LB RC 1500 2002 4.8L 4L60E 12 bolt 3.73 Richmond Lock Right AC PS Nelson Performance tuning
    Reply With Quote Reply With Quote
  5. 04-08-2007 01:55 PM #5
    2500HD6.0
    2500HD6.0 is offline Senior Member
    Join Date
    Apr 2005
    Posts
    202
    I found and another blown fuse it is the STUD #2* 30a MAX (in the top right side of the fuse box) hope that this will solve the problem I am going to loosen the blot that seals the intercooler so I won't run any boost as well as watch my gauge.
    2500HD 6.0 - K&N filter, TB bypass, Ported and Polished TB, no cats, SD Tune BY Nelson, 42# injectors, STS, T-67 .96 A/R, @5psi Walbro 255lph, Air to Water Intercooler, coolingmist kit @ 6ghp
    CJ-7 - K&N, TBI 350, dana44 front locker, 9" ford rear spooled three link, 38.5" SS, bead locks,and tons more.
    http://i44.photobucket.com/albums/f4.../100_04079.jpg http://i88.photobucket.com/albums/k1...eepcroped2.jpg
    Reply With Quote Reply With Quote
  6. 04-08-2007 02:10 PM #6
    2500HD6.0
    2500HD6.0 is offline Senior Member
    Join Date
    Apr 2005
    Posts
    202
    P1518 IMRC stuck open is a Ford specific code. 1518 in a GM indicates serial data between the PCM and TAC module has been lost.
    2500HD 6.0 - K&N filter, TB bypass, Ported and Polished TB, no cats, SD Tune BY Nelson, 42# injectors, STS, T-67 .96 A/R, @5psi Walbro 255lph, Air to Water Intercooler, coolingmist kit @ 6ghp
    CJ-7 - K&N, TBI 350, dana44 front locker, 9" ford rear spooled three link, 38.5" SS, bead locks,and tons more.
    http://i44.photobucket.com/albums/f4.../100_04079.jpg http://i88.photobucket.com/albums/k1...eepcroped2.jpg
    Reply With Quote Reply With Quote
  7. 04-08-2007 04:11 PM #7
    06BLACKMAX's Avatar
    06BLACKMAX
    06BLACKMAX is offline Looking for a Caddy
    Join Date
    Mar 2007
    Location
    Pittsburg, TX
    Posts
    210
    Here are a few pics of the install and the fuses that blew on is a 15 the other is a 20 blue and yellow.



    This is where we hooked up the boost pressure switch. We grounded it to the valve cover.




    My Ride: 2006 Chevy Vortec Max, LQ9, 4X4, no cats, 50 Series Flowmaster in factory pipe, 20"s, C.A.I., Custom tune by Dustin at TRT Performance
    Reply With Quote Reply With Quote
  8. 04-08-2007 04:52 PM #8
    2500HD6.0
    2500HD6.0 is offline Senior Member
    Join Date
    Apr 2005
    Posts
    202
    After I cleared the code and replaced the fuse and every thing is now running fine other than it sound crazy loud with no cats or mufflers lol

    Big thanks to 06Blackmax
    2500HD 6.0 - K&N filter, TB bypass, Ported and Polished TB, no cats, SD Tune BY Nelson, 42# injectors, STS, T-67 .96 A/R, @5psi Walbro 255lph, Air to Water Intercooler, coolingmist kit @ 6ghp
    CJ-7 - K&N, TBI 350, dana44 front locker, 9" ford rear spooled three link, 38.5" SS, bead locks,and tons more.
    http://i44.photobucket.com/albums/f4.../100_04079.jpg http://i88.photobucket.com/albums/k1...eepcroped2.jpg
    Reply With Quote Reply With Quote
  9. 04-08-2007 09:22 PM #9
    06BLACKMAX's Avatar
    06BLACKMAX
    06BLACKMAX is offline Looking for a Caddy
    Join Date
    Mar 2007
    Location
    Pittsburg, TX
    Posts
    210
    Not a problem, had a blast putting it on. Maybe one day when chesley lets me off my leash i can go faster than you!!!!
    Just remember you owe your daddy $20.00!!

    My Ride: 2006 Chevy Vortec Max, LQ9, 4X4, no cats, 50 Series Flowmaster in factory pipe, 20"s, C.A.I., Custom tune by Dustin at TRT Performance
    Reply With Quote Reply With Quote
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules