1999 2 Door Tahoe LSX Swap

[redaddiction]

how was the fitment on those seats i want to do my crew cab with some nnbs seats also. where the stock wholes close to match or no

Not at all, the factory bolts holes are offest so the passenger side bolts further forward. The NNBS seats all bolt together in line if that makes sense. I had to stretch the frame on the jump seat to go wider than the tranny tunnel.

I will say though it was totally worth it, they are a million times better than my old seats. The best part though is the jump seat has a lot more storage than the old center console and a 12v outlet in the bottom, and then it's even lockable.

[chvz99]

if you dont mind posting more fotos, i rather install nnbs seats on my truck iwas thinking of getting my seat re upholster but katzkin dealer came back at almost 3 k . n i can get some nice nnbs seats from e bay cheaper than this n will look alot better.

[redaddiction]

Anything in particular you want to see?

[chvz99]

maybe some that show the room between the seat and headliner and prob one from door clearance and seat.

[chvz99]

hows the swap going by the way?

[redaddiction]

hows the swap going by the way?

It's going, I may have a 6.0/4l80e to put in my truck instead of the 5.3. For the 5.3 I have still need coils/ drive by wire throttle body and flywheel then it's ready.

[redaddiction]

maybe some that show the room between the seat and headliner and prob one from door clearance and seat.

I'll snap those tomorrow in the daylight for you.

[smkur50]

Im on the fence about the pacesetter headers..have you installed them and did you need to extend the wiring for the 02 sensors? Or does the stock 5.3 manifolds and ypipe fit without any modifications? It's for my 98 2DR Tahoe Im getting ready to swap.