Got the engine, Now I need input...

[lost06]

I have been reading and have some useful info. But I have a few ?'s regarding what I have. I recently purchased a complete L33 and auto trans. When it was removed, It was completely unplugged and the only thing that was cut was the fuel lines about where the shift linkage is. It has all accessories including wireharness, computer, motor mounts, exhaust manifolds and pipes were cut off about 4" below the O2 sensors and finally the electronic gas pedal. All of this is going in a '96 GMC sierra.

So, with that said, I have ?'s because everyones set up is different and not all set up are complete so things have to be fabbed.

1. Do I have to have the wire harness modified? If so, why?

2. Is the fuel pump in my 96 big enough to feed it?

3. Unless I go ahead and put a cam in it, do i need to have the computer tuned for any reason?

4. Has anyone found a way to run the a/c in its current location?

I have more ?'s but these are the ones that are most pressing for me at the moment. Thanks.

[T-Stark]

1) harness needs to be merged with ur harness so work in the truck, ignition, power, gauges ect.

2) I would spend the extra 100 bucks and get the pump while ur at it

3) computer needs to be tuned to turn the security system off

4) ppl have notched the frame out to put the a/c in the factory side but it's a pretty big chunk to cut out and I wouldn't think it would be safe

[cottontop11]

Fuel pump is good. I think
Must have pcm tuned to remove vats. Might as well get a performance upgrade tune while ur at it
Wire harness will probably have to be modded. U dont need alot of the things on it. Rear 02 sensors for example.

[bobbylog]

You will need to run a corvette fuel filter because you have a 2005-2007 engine. (returnless)