2002 5.3 with older 4l60e out of a 96ish silverado

[myzterray]

will that trans work with that enigne and ecm? or do i need to do something else? my 2002 trans went out and i can get a new free 96ish silverado 4l60e. thanks

yea that trans will work fine. you need tlo get a flywheel spacer and slot the holes on the flywheel so they line up with the torque converter. the spacer will go betwwen the flywheel and torque converter.

[Venom]

wow really? so the electrical plug isnt an issue? will the converter out of a 2002 4l60e work in the older 4l60e?
so no tuning to the ecm or anything is needed?

[5.7stepside]

electrical is the same but conveter is not the out put shaft were the converter gos is a lil longer on the ls style 4l60e

[Venom]

ohh ok gotcha. will the flywheel from the 96 ish silverado work on the 5.3?
where can i find the spacer at?

[myzterray]

ohh ok gotcha. will the flywheel from the 96 ish silverado work on the 5.3?
where can i find the spacer at?

you would probably be better off using the flywheel from the 5.3. simpply take a dremel or die grinder and make the holes a little longer. i did about a 1/4 inch on each hole and it lined up fine. i got my spacer and bolts from jegs

http://www.jegs.com/i/JEGS-Performan...01010/10002/-1

and dont forget the longer bolts

http://www.jegs.com/i/JEGS-Performan...01011/10002/-1

the spacer will go on the transmission side of the flywheel before the torque converter.