CORRECT Front Wheel bearing adjusting procedure for '93 C1500 2 WD ?????

[dustiebutt]

Working on my '93 C1500 2WD. It's been a LONG time since I had to adjust the front wheel bearings.....someone please refresh my memory....repack, tighten (torque?)nut while spinning rotor , loosen nut, spin rotor again, (retorque?) tighten nut again, back off nut to nearest pin hole????? THanks!!

[tanz45]

Wow, never did all that before.

Usually just pack the bearings and install. Tighten nut by hand and spin, tighten by hand and spin. Too tight and you fry the bearings.

Drive it a bit and check for any play. If any, tighten by hand again.

*Yes i mean use a wrench, but use very little force.*