Stock torque verter w/new cam?

[ncravey]

I just ordered a comp xr275hr can I run this cam with the stock converter I want to upgrade eventually but it may be a little while before I do. Will this cam run ok with the stock verter and a tune?

Cam
222/224
.566/.568
112lsa

[Frenchy]

It will run fine, you just won't be getting the full effect, and it'll lose some low end. The whole point of matching converter to cam is to launch at a higher rpm in the new powerband

[ncravey]

Sorry the truck is a 2002 rcsb 5.3l,4l603 trans, 4.10 rear, long tubes, true duals, fipk, 80mm tb

[gTeran1]

Sorry the truck is a 2002 rcsb 5.3l,4l603 trans, 4.10 rear, long tubes, true duals, fipk, 80mm tb

you should atleast look for a tb stall man


but,like devin said. itll run fine with the stocker in there

[Beatdown Z]

you should atleast look for a tb stall man

Nah, just save up for a real converter with a 3000 rpm stall speed or higher.

[Tank]

The tune determines drivability.. tc would just optimize your setup.

[Tank]

Also tc keeps truck from surging at red lights if you have to crank idle up a lot.

[molitor]

thats the cam i just bought for my 370

i also purchased a TBSS stall, so yeah, would be a good bet to get a little bit higher than stock stall, even a 2k stall would be good