Ls6 Camshaft Swap

[foggy]

So are you installing a stock ls6 cam or that monster you posted earlier? They are on two different ends of the spectrum. The stocker is very mild and that other one is way too big even for a weekend truck.

Go back and read the entire thread, he only asked about the ls6 cam.

[randomhero]

Go back and read the entire thread, he only asked about the ls6 cam.

There were two guys asking about "ls6" cams. The OP only hadn't responded since he started the thread. The other guy was asking about that huge cam and he said something about an ls6 cam as well.

[NYAFACE86]

lo.. i was asking about that huge cam for the ls6 but i am biding on it, so if i win i win... but i thing i will just get the ls6 stock cam and put that in... my 5.3 i will be porting the heads on my truck...

[NYAFACE86]

what about this cam? is this any good>

2008 6.0L Camshaft w/ Lifters VVT 6.0L LSX LS3 LS6 L92

18:05
156/08eng
2275

2008 aluminum block 6.0L VVT truck engine with only a few minutes of run time on it. Comes with the cam, lifters, lifter guides and bolts. My description is only a guide and I cannot guarantee it is 100% correct, just what I found. Sold as-is!

[NYAFACE86]

or this cam

236/242 .580/.590 112LSA

copy of the 288HR comp cam

[WARLOCK]

If its a regrind stay the hell away from it. There have been many members on here that have needed new motors after installing one. Ask around about them.

[NYAFACE86]

not sure if its an regrind. i found it on ebay that s what it said on description. but i went to ls1gto.com and found the guy on the forum that is selling them on ebay lol.. wierd lol.. and it dont say the same that its a copy.. so i dont know what to think ...

[WARLOCK]

If its a guy based out of plano texas then its crap.

[NYAFACE86]

If its a guy based out of plano texas then its crap.

its regrinded so nvm! lol... thanks for the heads up on regrinded cams

[NYAFACE86]

i just found a 6.0 camshaft off a 08 chevy truck, is this the same as a ls2 cam? and would this cam work with my 5.3l?