cool sweet write up. this might be one of my next mods over the winter.
cool sweet write up. this might be one of my next mods over the winter.
2003 Black Silverado SS,Bose, New Headlights(Black) Amber DRL's,Slyvania Silverstars ST,Carriage Works 5 piece Billet Grill, Shopman 1 Bowtie SS(Polished),AEM Brute Force CAI, Magnecor Spark Plug Wires, NGK-TR55IX Plugs, AVS Vent Visors,Silveradoss.com decal in Silver(reflective),Painted Engine Covers in Silver n Black,Custom made Dash Plaque, LED bulbs in taillights,Blue interior lights, chrome gauge bezel,Goodmark Steel Cowl Induction Hood,chrome skull an bones SS trailer hitch, Toyo Proxies ST's 285/50/20,Mag-Hytec rear differential cover, royal purple fluids, custom bowtie with SS decal, Tinted Tails and 3rd brakelight(by sprayed99),Mobil 1 oil cap and emblem,more to come
Worth every penny!!!
'00 1/2 TON ECSB 5.3L 4L60E
K&N Filter,Gibson Exhaust,Superchips Programmer,Billet Servos,'03+ Taillights,White Door Handles,Carbon Metallic Grille Emblem,6000K HID'S
Thanks..very helpful post...
very helpful thread! i installed a vette servo today its one fast, easy, and low cost mod.
1982 c10 lsx swaped, NP tuned, true duals, 4:11s, trutrac, e-fans, CAI
So which servo do i need to buy for an 04 silverado with a 4.8? is this mod worth it? Could i install this my self with no prior tranny work knowledge?
04 5.3
224/224 .566 .566 114
3200 Circle D
LT's
60e
Nelson Tuned
p1sc in closet
All 4l60e's take the same servos. Few tips.
1. Have extra cover orings. Usually when you remove the cover, you have to destroy the oring. Test fit the assembly before you put the oring on the cover. Make sure the servo assembly compresses about 2 inches when installed. if its stiff and wont compress, take it back out. (hence why you dont put oring on cover.)
2. Make sure you install the rings right.
3. dont bend the clip that holds the assembly in the tranny.
Do the Vette servo swap. You can get them most anywhere. I get mine from OregonPerformanceTransmissions.com . Be sure the wiper style oring on the last piston you install has the edges pointing outwards of the transmission, towards the inside of the cap that it fits within.
Anyone can do this assembly with patience and a cool engine.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
well ordered it today from oregon. Cost 20.50 shipped
04 5.3
224/224 .566 .566 114
3200 Circle D
LT's
60e
Nelson Tuned
p1sc in closet