Will I have any problems using Infinity speakers with my stock HU? The 4x6 plate in the rear says 9.5 ohm. The Infinity is a 2 ohm. Any problems?
Will I have any problems using Infinity speakers with my stock HU? The 4x6 plate in the rear says 9.5 ohm. The Infinity is a 2 ohm. Any problems?
95 SILVERADO EXT.CAB-5.7-175,000 AND STILL GOING-LOOKING FOR 5.3 SWAP
I just put in some polk audio in the front on my stocker adn it sounds really good.
Name: Mark,
God created turbo lag so nitrous trucks could have a chance.
http://www.ls1truck.com/forums/my-ga...tml#post274877
I'm putting in 6X8 Kappa 682.9 2 way in place of the 4x6. I had a previous post about the install. Now, The speakers will play fine for a while, then stop playing. They will not resume playing until I remove the passenger side rear speaker. Then, I can reinstall it and they will play again. I think I have a ground issue, but not sure. Any way to tell?
95 SILVERADO EXT.CAB-5.7-175,000 AND STILL GOING-LOOKING FOR 5.3 SWAP
Any way to check if this is the problem?
95 SILVERADO EXT.CAB-5.7-175,000 AND STILL GOING-LOOKING FOR 5.3 SWAP
Yep. factory Delco 4x6 plates. 9.5 ohm
95 SILVERADO EXT.CAB-5.7-175,000 AND STILL GOING-LOOKING FOR 5.3 SWAP
Id say thats your problem. But just to see, use the positive off your left speaker and the negative off you right speaker and then run a wire from your left neg to your right positive and see if it produces sound for a longer amount of time without shutting off. With this set up you will be running at a higher impedence.
I'll tell you some more info...the speaker i'm talking about will produce sparks when the basket is touched to ground. Not always, but sometimes. I can remove the speaker, lay it on the seat, and it will play for as long as I want.
95 SILVERADO EXT.CAB-5.7-175,000 AND STILL GOING-LOOKING FOR 5.3 SWAP