LS2 With LS3 Head's And Intake

[midnight04]

I am letting go of my LS2, It is fully built and ready to go, I think I'm going to pick up A 6.2L LS3 Block and stroke that. My LS2 has the following:
USED LS2 Block with under 15,000 miles on it
USED LS2 CAM
NEW ARP Head studs,
New Oil Pump
New Timing Chain Set up,
NEW Lunati Forged Crank Stock Stroke 24X
NEW LS2 Rods
NEW LS2 Pistons
NEW LS2 Lifters, And Trays
New LS2 Valley Cover With Vent
NEW LS3 HEADS With .570L Springs, Stock Rockers & Push rods
NEW LS3 Intake With Rails And Injectors
NEW LS3 DBW Throttle Body
Used L92 Truck Pan With Pickup and Windage
Used Front and rear covers.
Used Crank Sensor, Used Cam Sensor
ASKING $3,800.00 Plus Shipping!Here are some picks of the Crank being installed, Ill get more Picks as I find them It was Finished a couple of months ago.
We all know I build on the side, so you can rest assured this one was built for me to go in my drifter, It is stout. You can run the LS2 24X reluctor engine with a stock Vortec or LS1 harness and a simple cam adaptor harness and knock harness adaptor. Easy butter cheesy..