Quote Originally Posted by Vince @ FLT View Post
On the valve body side my book is calling that passage orificed exhaust oil. On the case side the circuit is 3rd gear feed. So with that being said if you do not have the gaskets cut out as you were told then circuit can not be completed. I think if your clutches in the direct are ok, with doing this it should work. Hope this helps. Vince
thanks Vince....after spending a couple hrs looking at this I came up with the same results as you.
Im crossing my fingers that installing the gaskets with these holes punched out I will regain 3rd and also my reverse seeing reverse cannot happen unless the direct clutches are applies.

I figured it was an old kit caused the instructions say 1995

Thanks once again...I will post results when I reinstall VB