Assuming others have done this. Not sure where I can find a bracket for a cable throttle body for a 6.2 truck intake. Anyone have any advice or options? Throttle body is an edelbrock 90mm.
Assuming others have done this. Not sure where I can find a bracket for a cable throttle body for a 6.2 truck intake. Anyone have any advice or options? Throttle body is an edelbrock 90mm.
Iv been searching for the exact same thing....with no luck. If you find anything be sure to share!
2008 GMC Sierra SLE....370ci LY6 with some goodiesSOLD
1995 C2500- LS1 swap with a mp112
build thread- http://www.ls1truck.com/forums/lsx-t...-ls1-swap.html
Will do for sure. So far it seems like the one from ws6 project for the car intake might be the best option with a little modifying to clear the evap hose
I bought the cable bracket from ws6project and have it installed i just need to reroute pcv line, so far im pleased with it.
What one did you buy? The one that bolts to the back of the tb? And what tb are you running?
chevyman94 will you post a pic?
2008 GMC Sierra SLE....370ci LY6 with some goodies
1995 C2500- LS1 swap with a mp112
build thread- http://www.ls1truck.com/forums/lsx-t...-ls1-swap.html
i bought the ls holley cable bracket its a 95mm part number 20-147, it bolts up in between the throttle body and the intake, and the gaskets are included. Website was
ws6store, as far as the throttle body i just bought a 92mm ls2 4 bolt design off of ebay.
there was no problem with the difference in size of the tbody compared to the flange piece? Seals all tight? Any pictures actually ?
i didnt' find any issues when i was putting it together. after install i started it up and checked for leaks and i didnt' find any.
That looks nice actually. Wonder if I would run into any issues on a 90mm tb. I don't think I would after seeing that one. Yours is only 2mm bigger. Thanks for the picture!
Posting Permissions
Reply With Quote