Does anyone know if it is possible to turn the steel neck on the truck water pump? Have any idea what the press is on that? Any info would be very helpful! I'm going to be running a water to oil heat exchanger and it would be much nicer if I could face it toward the back.
Anyone??
grab on with a pipe wrench and push it over while tapping the water pump with a brass hammer. it will slowly turn
old mod list: H/C/I/N/E/G 408
new mod list: 5.3, gears/posi, mufler and tune : (
Will it come all the way out or is it pressed in there pretty good..?
id apply heat to it to help allow it to move
2002 Lightning - GT headed 5.5Litre w/ Twin 7665s
2002 Silverado - 427Lsx w/ Twin gt4202s
2010 Silverado crewcab Z71 - 5.3litre w/ procharger
2000 Wrangler - 5.3litre with some stance
2014 Xsport- 3.5 Eco boost
412 Motorsports
it ain't that I'm too big to listen to the rumors, It's just that I'm too damn big to pay attention to 'em..That's the difference
Just got it out. Just tapped it with a rubber mallet back and forth a few times while turning it with the pipe wrench slowly. It broke loose, then just wiggled it back and forth and it came right out. I'm gonna knurl it and put some blue loctite on it and put it back in its new orientation. Thanks!
Posting Permissions
Reply With Quote
