Please confirm my Fuel filter is connected correctly

[Z-Rod]

I have installed my AC Delco GF 845 fuel filter and regulator in my 1994 Z-71. It has one 3/8 fitting on one end, and two fittings on the other end, a 5/16 fitting in the middle and a 3/8 fitting next to it. (See picture)

After running air thru the filter, It seemed apparent that the inlet was the single 3/8 fitting, the outlet was the middle 5/16 fitting and the return was the 3/8 fitting next to the 5/16 outlet. Is this correct?

I have run the truck several times around town and have had no fuel issues... It just doesn't seem the way I would have guessed the connections should be.

Thanks,

Z-Rod

[PitchBlackC3]

Is that number the Corvette filter? If so the single line is the outlet. The way you have it now should work, but the filter is running backwards.

[Z-Rod]

No, for whatever reason I used the filter/regulator fora 2003 4 cyl S10. I looked at my plumbing and it will just be a matter of flipping the filter around and shortening the return line.

Z-Rod

[RedHeartbeat]

yeah, the two fittings side by side are the inlet(3/8") and return to tank(5/16"). The one by itself goes to the engine.