I have a harness off a 2001 5.3 and there is a section cut off. Its where it y's off the 1st o2 sensor from the same strain of wires as the 4l60e connector.
Anyone know what it is. I did a continuity check and there are a few wires that go the pcm and a few that go to the firewall (connector)
Says its the Range Swith Siganls, powers, grounds...Is it a PRNDL or ?????
Some of the wires are
Wire------Connector
Grey------Red 62
White-----Blue 34
Blk/Wht---Blue 32
93 ECSB...lq4 6.0 swap, 255 walbro,cai, ported tb, shorty headers, 3" exhaust, tune,electric fans, NX wet kit 100 shot, 2/4 drop, beltech shocks, boss 335 22's, 295/30/22...looking for a cam.
grey-----red 62= PRND C
white----blue 34= PRND P input
blk/wht--blue 32= PRND A input
1983 Ford Ranger- 2.3 to 205k mile 6.0 swap
thats what i figured it was. i just need to know what wires go where. There a total of 10 wires cut. I know where they are on the pcm just dont know on the connector on the firewall.
Oh and this is for my s10/5.3 swap
93 ECSB...lq4 6.0 swap, 255 walbro,cai, ported tb, shorty headers, 3" exhaust, tune,electric fans, NX wet kit 100 shot, 2/4 drop, beltech shocks, boss 335 22's, 295/30/22...looking for a cam.
a little research goes a long way...
if anyones interested...
Neutral Safety Switch Questions - LS1TECH
Last edited by rammor02; 05-10-2010 at 11:13 PM.
93 ECSB...lq4 6.0 swap, 255 walbro,cai, ported tb, shorty headers, 3" exhaust, tune,electric fans, NX wet kit 100 shot, 2/4 drop, beltech shocks, boss 335 22's, 295/30/22...looking for a cam.
Posting Permissions
Reply With Quote