98 obs z71 to 09 6.0L repin question

[Neil103]

I am fairly new to this forum and see a lot of great info on these ls swaps here. I have an 09 LY6 that I am planning on putting in my 98 z71. I have deleted vvt, swapped cams, and acquired an 0441 PCM. I was wondering if anyone had the re-pin info to reuse my obs harness as I have seen people talking on this subject before but didn't want to butt in on their thread, so I figured I would start my own. Any help would be greatly appreciated.

[Lextech]

Your 2009 engine is a Gen4 series which is a 58x engine. The 12200411 PCM will not run that engine. That engine will use an ECM. The ECM will not run your gauges. In my opinion you would be better off getting a 24x Gen3 engine which would support the 0411 PCM repin.

Jeff

[Neil103]

Well, I was planning on using the lingenfelter unit that converts the gen 4 cam and crank signals to 24x. And also using a cable 4 bolt aftermarket throttle body with iac valve and tps off of 01 Silverado throttle body which was ran by the 0411 pcm. Basically making my 6.0 a gen 3 to the 0411 pcm. That's what I have already and figured it would all work together. Or am I still missing something?

[Lextech]

Hhmmm, That should work. PM me your e-mail address and I will send you the wiring file for the repin.

Jeff