sold...
Printable View
sold...
You should post up if its a three bolt or single bolt cam, Gen3 vs Gen4.
thats a damn good cam, if i had the dough id just buy it and put it back for another build glws :thumb:
Would work well for me but I am into another hobby right now and don't have the $300 plus springs and push rods or the time to put it in but I want it none the less......long sentence....
good 5.3 cam....
What about 4.8
It'd be lots of fun in a 4.8
+1 with a good size stall it would be fists full of fun.Quote:
Originally Posted by Frenchy
Nice what would the rpm range for this cam. A stall is in the works what rpm range for that and i have a set of 4.10 that need to be put in. Would it work for a highway dd?
I googled the part number a few days ago and I think it was 2000-6500 iirc. A 3600 stall would probably work well especially in a 4.8.
haha i have been wondering what iirc was i just had to google it
Almost the same cam i run did fine for me DD
PM sent
3 bolt
some guy from the valley ran 11.8 with this cam on a 4.8 /nitrous..