Printable View
I got this truck more than a year ago, been sitting since.
Keeping the body as is, has a little rust on it, scratches, but overall it's pretty clean.
Installing a 5.3L Gen4, 60e, NP engine harness using 2010 vette components such as pedal, maf, ecm.
Has a Vintage Air system.
Gonna add a 4" driveshaft, good shocks, springs.
Heater/ac/cruise
Keeping it a nice, quite cruiser, with stock exhaust.
ZO6 cam, dod delete
Here's the truck.
That is not what I was expecting to see. That is a pretty good looking truck.Quote:
Originally Posted by farmtruc
man im so jealous of those southern trucks
Just don't sell it after you make it awesome!
Can you give some more information on the wire harness? Why the 2010 components? Are you starting from scratch on the harness, like using any of the 68 components at all?
thx, ya it's pretty decent but I don't wanna spend $5K on a paint job then sale it.
The engine harness: just one of our new 2010 e38 ecm's and tcm. all new components like the ones we sale online. might build the harness on the bench then make it tight and finish it on the truck. Grommet thru the wall and modules mounted inside.
Vette pedal because it's small, or the caddy v6 pedal.
2010 maf and throttle body.
38lb or so injectors
Gonna use the pwm fan controller from the vette.
ac, fans, defront will work off the ecm as well.
gotta nice little fuse block i'm mounting inside; it'll supply power to the harness and chassis wiring, luckily there's not much chassis wiring.
That sounds like it will look super clean.
Thx ducky.
Got the engine stuff painted today and front frame. Gonna drop it in tomorrow along with the freshly built Trans 60e.
change of plans
LOL! We were waiting.