Printable View
I'm tired of searching! Been looking for days and only found a pin out for 96+ and it didn't match my wire colors. anyone know were I can find it?
Need to hook up my tach, vss, and mil wires. The c100 (black conector driver side fire wall) has 2 white wires so I'm not sure which it is and really don't want to remove all my wiring loom to trace it. The mil, and vss I can figure out but would like a pin out to double check those before I start tapping into wires
Mine is a 94 and I know things can change a lot in a year, but this may help. This is what the back of my instrument cluster looked like, sorry it is a poor quality pic.
http://i1049.photobucket.com/albums/...1359417993.jpg
I then used this diagram and a volt meter set on the continuity check, and traced each wire. Most came out behind the glove box (speedo, tach, SES, ect) and the temp, oil and alt/volt came thru the C100. Here it is
http://i1049.photobucket.com/albums/...pscfbd1bb6.jpg
I have like you, searched hi and low for a C100 pinout will no luck at all. I just had to break out the volt meter and figure it out.
Think I found what I was looking for finally, the vss wire goes to 2 wires pulled from a connector that goes to the vss buffer/DRAC behind the dash so will my cruise still work after this? Also fond the plug with mil/tach wire
Also, being I'm 5 speed manual trans, do I need to hook up the purple brake switch wire? The on that tells the pcm when you let off the gas?
Woops, double post