Coil Relocation

i know there are people on here that are moving the coils off the valve covers, i would like to know where they are putting them, and if anyone has pictures of the new coil placement.

http://i948.photobucket.com/albums/a...918_211836.jpg

http://i948.photobucket.com/albums/a...918_212038.jpg

http://i948.photobucket.com/albums/a...924_171046.jpg


used LT1 plug wires, made my own brackets

thanks for the pictures, did the gas lines get in the way? and thats a bad ass motor

we've been putting them down below mounted on the oil pan, mounts, etc, really hides them and cleans up the engine bay.

What have you guys done, as far as wiring harness, to accommodate the relocation of the coils?

Quote:

---

Originally Posted by bangbangskeetskeet

What have you guys done, as far as wiring harness, to accommodate the relocation of the coils?

---

pull the coil harness to the back of the engine, then install the extensions, that's it.

i rerouted/extended my harness a few years ago to make it long enough. However you can buy the extensions which will work for you

Quik, is that block backwards? I see water pump and snout at front, and turbos back???

Are you on drugs?

to extend the harness is there a extension harness that some one makes, or can you just cut out the origional harness and pull the plug out to make it longer and then tape it back up