Printable View
Hey all, I'm about to do my first swap. Putting in an LS1 or LS6 (whichever I can find) in my 1999 Chevy SWB. I ran across this engine. Thoughts on the price?
"2000 Corvette LS1 with 21k miles for $3900 with accessories, sensors, computer and factory wiring harness." Seems kind of pricey to me, but I'm a noob. lol.
If this high, what should I expect to pay for a complete engine?
Thanks for the help. You'll be tired of me after this is all said and done!
It better come with lube and a 3 course breakfast in the morning. If your truck is already a V8 all you need is the longblock, then swap all your 4.8/5.3 stuff over. If it's a 4.3, you need the truck harness and PCM
HAHA!. That was my initial thought as well - I hate it when it's dry. But, since I'm new to this swap thing, I wanted to ask the experts.
Unfortunately, it's a 4.3 so I do need the pcm & harness, not to mention all the other misc. crap.
Ah well ok, I suggest you read the sticky on the swap. But being a 99 it's fairly straight forward. Get a 99-02 harness, appropriate mounts, all your accessories, lines, hoses etc. Best thing to do is find a wrecked truck and take everything in the engine bay. What motor you use is up to you, 4.8/5.3/5.7/6.0 are all the same engine family. Me personally would go with a 6.0, either version would be good. Reason being is cost, your ACTUAL LS motors will cost an arm and a leg. A decent cam and heads on a 6.0 will outperform your LS1 and LS6 and still be a lot cheaper.
Quote:
Originally Posted by Frenchy
Pretty much spot on. You can find a used 6.0 for a 1/4 of that price.
Thanks.. Will for sure start looking for a 6.0 now. Damn, those intakes are ugly. lol.
An LS6 intake can be used on the 6.0. The TBSS or NNBS intake is the one you want to use if you have a little spare coin.Quote:
Originally Posted by rkwhite61
i paid 750 for a long block lq4 out of a 2005 denali. it only had 20k miles on it. got the p/s bracket and pump, water pump, fan clutch, a/c bracket. coil packs, flywheel.
just look around. your wrecking yards will be the best place to look. or just check on here or even craigslist. 99-2000 6.0 are iron block/iron heads... 01 - 07 (classic) are iron block/aluminum heads, 07 newer are alu heads/ alu block (i think...)
depending on how you want to build the motor... iron block would be your best bet. with the 6.0 block, you can swap the ls3 heads and intake assembly onto it just by bolting it on.
short block with decent rotating assemblies go for 350 +, long blocks can be found from 500+ (just besure to figure out the year the motor is from or you might run into problems if you want to swap a 4l60 versus a 4l80....
cams are your friend!!!!!
oh... forgot to tell ya... the difference between lq4 and the lq9 are the pistons... the 4 has dished pistons and the 9 has flat tops.... other than that, they are identical... the lq4 has 9.4:1 compression and the lq9 has 10.0:1 compression.
also shoot for a 2005+ 6.0 if you can. they beefed up the rods for the newer models.