1988-1998 LSX swap info

[ss454327]

I totaled my '99 camaro but didn't hurt the drivetrain at all. How hard would it be to swap my engine and trans into the OBS trucks? I obviously have the entire harness and computer from the LS1 as well as a racetronix fuel pump I can pull from the tank. This motor had 9k miles on it when I bought the car and I didn't put another 4k on it. It has LS6 heads a Vinci truck cam and an LS6 intake as well as a fully built 4l60 with a SSF stall. It was a high 11s setup in the car so it should be a low 12s setup in the truck right?

[Chevy-Art]

It will take some work, but it is really not too hard to do. Also at the top of this http://www.ls1truck.com/forums/lsx-truck-conversions/ there are three stickies that will really help you out. Lots of good info. What year GMT-400 are you going to install the LS1 in?

[ss454327]

Well I was looking at a clean '91 but found a super clean 1996 V6 RCSB S-10 for $500 ON MY STREET! HAHAHA It's litterally four houses down and interior and exterior are perfect. The 4.3 runs but is a bit rough. I did some readin at CPWs site and I can get the LS1 harness modded for $450 and since it is a '96 and up the LS1 computer will run everything in the truck alone. No need for both PCMs! I'm probably going to get their poly mounts and headers since they are known to work. Should have around $2k plus my drivetrain in it when I'm done.

[RPM Graphics]

what is CPW?

[1989k1500]

Current Performance Wiring is probably who he is talking about.

[lechez71]

i got my harnees reworked from nelson performance for the same price, but they went out of there way and got me the connectors that were missing (on gen4 motors theres some type of connector that sends comm to the odb2 connector, got that for me no charge). when i got the harness back, i connected it and truck fired right up, saved me the headaches if i would have done it myself...

[ss454327]

i got my harnees reworked from nelson performance for the same price, but they went out of there way and got me the connectors that were missing (on gen4 motors theres some type of connector that sends comm to the odb2 connector, got that for me no charge). when i got the harness back, i connected it and truck fired right up, saved me the headaches if i would have done it myself...

Thanks for the heads up...I might give them a call. CPW doesn't want to mess with my harness and wants $850 for a complete one. No way am I going that way. Oh and just an update...

I used the fuel tank from the Camaro and fabbed a spot for it behind the axle and dropped it in. Fuel system is plumbed and the motor and trans are in. The frame was pressure washed and painted Krylon Rust Tough Enamel semi-flat black too. Cab goes back on monday.

[ss454327]

Got some more work done today.

[RPM Graphics]

looking good!!!!!
i can't wait to start my swap.

[RedHeartbeat]

OMG! Where's the rest of my truck!

looking good. I like the nice clean frame. Makes me want to puke when I look at my truck's rusty old frame.