Forum: Forced Induction

critique my fuel system. twin 255 walbros to -8 feed to -8 y block to each rail crossover to fpr mounted to passenger fuel rail -6 returned to...

this seem like a good one? or any recomendations....which one are you guys running?

is there anyone that sells the direct drop in for the nbs trucks so i dont have to do all the fitting for the walbro 255??? or am i gonna have to do...

dont want to seem like an idiot but where do i mount the map sensor at still new to this so dont be mean

All composite tank only. 99.00+ freight Comes with tank, lid, brackets, and outlet fittings.

I was gonna put some e3's on my truck this weekend and was wondering if there was a need to go ahead and change the wires, seems like I've heard...

Ok guys, there are a bunch of fuel system threads out there, but a lot of them are just bits and pieces of the system. So I decided to make a thread...

I would like to know what every one uses for gas.. Are you guys running boost controller that allows you to turn down the boost for 87 then back up...

what gearing do you all think would be perfect for turbo setup...will be changing out the ring and pinion in a week or so.... i have a set of...

Ok well after some thinking and talking to Bryan a little bit (jetmech) I just started looking at the trick stage 3 turbo kit. ...

Well, I'm not too happy with how loud my truck is with the rear mount 94mm turbo. Will it hurt anything putting a muffler like...

I am purchasing a twin turbo kit and planning to put it on my 2008 5.3 z71. from my research I have found that 8.1L Marine injectors 44# would be a...

Im getting ready to start building a log type turbo manifold, what kinda of steel do you use and where do you source it at????

Thought I would post here selling my NEW 2300 kit. Still in the box, front inlet, jackshaft, complete with box 2. ...

My latest data log showed my injector duty cycle is a little too high. I'm currently running a walbro in the tank and bosch 60# injectors (at 4 bar)...

Lookin at slappin this set of 241's on my 4.8 and doing a rear mount set up, ive heard mixed opinions on rear mount turbos. Seems like it would be...

I've been using the stock 3 layer gaskets on my setup. Wondering if anything is available that will hold up better than the stock gasket?

hey guys, i dyno tuned a vette last saturday on the engine dyno. we ran into belt issues. we want to upgrade this system with a 12 rib setup...