HP Results
how much hp do you think ill get with a nelson tune ... which is on the way
i need to dyno my truck i think next week ill do it after work.... what numers you think ill put up???? also any quarter mile estimates?
we got it done we think...we were getting some crazy #'s a few pulls and the best we could come up with was 367 hp at 431 tq.it was makin some wild...
SPeedy's here in Owensboro, Ky finally had a Dyno Day so naturally I joined in. My stock 5.3 other than a K%N FIPK and exhaust put down 220rwhp@4800...
i have a 99 Z71 5.3 with a granatelli mas air sensor...K&N intake..tornado..airaid tbspacer...msd wires...bosch plat 4 plugs...granatelli predator...
first off the guys at total performance are jack asses. they strapped to the sway bar :nutz: :nono: at first untill i ranted and raved :tantrum: ...
I dynoed the truck today. Did 3 pulls. Here are the results. 5psi 349hp 370tq 7psi 383hp 404tq 8psi ...
well it has come time to strap her down finally. the last few times i have tried to something either with the truck or some weird force has kept it...
Hey guys, I did some trouble shooting today and finally got that ugly hunk of junk on the dyno. It pulled off 383hp/387tq. I'm not sure what to...
261RWHP/284RWTQ not too bad being a '99...Zed
409 hp 540 ft/lb torque. Mustang Dynojet :point:
Here you go guys, a stock 6.0L graph vs an STS equipped with 5psi. Jerry was nice enough to come all the way from Louisiana and dyno this thing. ...
This my 05 2500HD 6.0 4l80E 10.5" Rear Diff 1st my speed limiter kicked in at 92mph/4600rpms in third. I believe I made highest #'s in second...
This is the first time I have dynoed my truck since I swapped to the LS1/T56. The only internal mods is an 02 LS6 Cam. I have the usual external bolt...
I went to MTI Saturday with a couple other trucks for a dyno day. I was expecting my truck to put down abut 230-240rwhp. My truck was the first to...
well I went to a dyno GTG from the DTW site. They had invited me to join them over at Flat Rate Performance in Pearland. still havnt got any tuning...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules