Forum: Powertrain

I'm at a loss at which way to go for lowering the front of my sierra 2 inches. I would really like to do a 4/6, but I need to keep the ground...

Alright, so I am working on a 2004 Chevrolet Express 2500 van, but I believe that the spare tire setup is the same as the pickups. I have read the...

What is the best way to keep the crankshaft from turning when trying to remove the crank bolt on the balancer? I don't have the luxury of an impact...

newb ? i have a 224/230 .581 .591 112lsa cam in my 5.3 and was wondering what a good stall would be going through a 4l60e? any info will help Thanks...

How often do u change the trans fluid /filter and rearend gear oil help me out guys

Are the mass air flows interchangeable between 4.8,5.3 and 6.0

I need some suggestions.... my buddy keeps telling me to get my rebuild kit from monster transmissions but the kit i want is like $800... i saw a kit...

I was swapping valve springs and one of the valves seemed like it was hung up on something. I though it was bent so I got my calipers out and rolled...

Looking into buying one of these, what part # do I need?...

What is the going price on an LS1.... my buddys dad owns a machine shop and got an ls1 out of a 2000 corvette and pretty much cleaned it up and he...

Ok I've been reading on here about put a corvette servo in trucks and I was wondering what is it and what does it do?? Sorry for the dum.question

Wondering if this is a normal backlash noise or not. Ebrake is on holding the wheels tight. I also took the DS off and did the same thing. Seems...

What are your experiences with the 160* thermostat. I understand that, obviously, the engine will run cooler but my only concern is how the rings...

http://kalecoauto.com/index.php?main_page=product_info&cPath=4&products_id=11&zenid=u3q79l3nbhsnvo9q01a7krkuj5

Ok so I never use my 4wd and it's hard(er) to do a good drop on a 4wd so I'm looking into removing all the 4wd stuff...anyone done this before? Any...

I have a 2000 z28 camaro that runs 10.5 on motor, ported heads tv.2 cam 232 234 .595 .598 113 lsa, 3600 stall Looking to go MS3 cam in the camaro so...

My buddy has a 01 Silverado with the 8.1 in it. He put a programmable chip on it to increase hp and gas mileage. He claims that it can be...

Alright. I recently found out I need a shim /washer between the flywheel and the verter to make sure the converter is far enough into the trans. Is...

I have never had this problem so i dont know what exactly this is but im guessing my tranny is slipping. i go to Drive and i give it gas and it just...

Picked up an 06 longblock, with 31K miles. Started cam swap and #3 camshaft bearing fell to oil pan, and cam journal is blackened. The entire engine...