Forum: Powertrain

ok, i got my new headers (lt's) and 4'' catback on and the avalanche is lacking power bad, it was running ritch with shorties and dual 2.5'' exhaust...

I did some research a few years ago and go sidetracked on another car project. I was never able to confirm if a manual swap is possible in a 1500...

this has been going on for a while but when i go to start my truck i have to cycle the key and let the fuel pump prime a few times and then try to...

I am buying this motor from a friend but needs a crank, pistons, rods and bearings. heads are complete. I dont want to buy the wrong stuff for this...

This weekend Im installing the USA Valuetrac and also bought a master install kit. My question is r there any tips for setting up used gear?. The...

I need rear end gears BAAAD. I am buying a set of richmond 4.10s along with a master install kit and royal purple gear oil. I have been looking for a...

hi guys. i am new to this site, but someone gave me this link and told me that this is the place to probably find some answers to the questions i...

Looking for a better spring, I have v6 springs on my truck and with all the weight reduction the front end keeps getting higher. Truck is in the...

looking to see if a factory a/c compressor off a 5.3 will work with this bracket kit http://www.kwikperf.com/lsx_ac.html

Every few months i get a left bank lean code and CEL light on, any ideas? I have a cammed 5.3, LS2 injectors, Walbro pump, Nelson 93 tune, headers,...

Ok, I've noticed the past couple days that my tranny(4L60E) is starting to slip. It's happening at low rpms just after starting to accelerate from a...

so i found a 220k mile lq4 for 700$ at a local yard. what have your exp. been with high mile gen 3's? is this what you would call a good deal? same...

So about 6 months ago i had my tranny rebuilt. I guess the drifts, donuts, burnouts,offroading, hauling, pulling.... got to it :dancenana: Well about...

i know im going to get flamed hard for this but i don't mind if i get the problem im having solved. I'm having a problem with my fathers 01 accord...

Hey guys gonna do a gear swap pretty soon and wanted some more input. My 95 ecss z71 has a lq4, mainly stock, Cai and will be nelson tuned within the...

Im just making sure im ordering the right parts for my truck. Im going to do a corvette servo ...

Will someone get me the dimensions from outer tire to outer tire? Just need to see if I pick up an entire truck, if I'll be able to use the entire...

lo0king for replacements as you read this

I currently have edelbrock ias shocks on my 2/4 drop 01 silverado, im looking for a shock that rides smoother and not so bouncy..i do have shock drop...

Who has actually put one in? Anything special to look out for or is it basically the same as any other 60e/80e stall install? I'm looking at a 3400...