Forum: Powertrain

Whats everyones opinion on them?

I have an '02 Silverado 2wd ext. I can't decide where to spend my $ this time. The truck has aprox. 125,XXX mi. on it with all the original...

I've been busy tearing my engine compartment apart all day only to find that I can't get the block apart from the trans. I think the two tabs on the...

Hey guys i just ordered a t56 out of a 04 gto. i believe i need a starter for a gto. Is this right? Thanks in advance

Greetings, Figured I’d dive into the knowledge of this forum since I’ve been lurking around the web for a while and can’t seem to come up with a...

I have error code p0449 evap solenoid error, and I'm getting a tune from blackbear next week. I was thinking about having him just delete the evap...

So it seems my 4L60E has bit the dust and I'd like to replace it with a mild 4L80E but I'm concerned about the loss of low end power due to the tall...

Called our Chevy parts dude and got a price on a new tranny (4l60e) and he quoted me $1500, comes with a 3 year 100,000 mile warranty. My question is...

I recently purchased a ring and pinion, posi, and master install kit as a package from Ron's. I had no clue how to do the install so I sought out a...

so i notice a ticking noise coming from number 7 header tube it goes away when engine is warm at idle but you can hear it when you give it gas going...

I was wondering if the 09-10 posi trac that GM has on the trucks work on a 00 rcsb silverado? I would like to know if he splines are the same? Thanks

http://ls1tech.com/forums/manual-transmission/1513422-how-prolong-life-your-clutch.html Interesting stuff.

I am about done buying parts for a 5.3 build, It was suggested to me to get LS7 lifters. What gain is there in these lifters compared to stock 5.3's?...

Is there a plug I can use to put my gauge sender in a 4L80e like there is on a 4L60e? I couldn't really find any info. Also, would a deep pan clear a...

Ok, when I did my fuel system, details in my build thread, I removed all the evap stuf except the lines. I am having problems filling the tank, it...

So with some fancy craigslist work, luck and some phone calls I ended up with a 6.0 and ls3 heads for nothing. It started off with selling a 4l60...

Anyone on here tried the Wilwood rear disk kit like seen HERE It seems reasonable considering it includes the bracket, rotor, 4-piston calipers,...

So I picked up this motor for my dad from a guy who passed away's daughter. Basically she has no idea where it came from. It has 799 heads and...

Just wondering a few things..first off some of you know I'm running a built 4l60 4wd behind my 6.0l..this is the second time it's started to...