Forum: Powertrain

what cam would be good for me. ive got a CAI, mid length headers, exhaust, and a servo. the only other mod im gonna do is a tune? its my DD too.

ok i have had the 5.3 silverado and now i have the ss and i was wondering, i want to do the 160 thermostat and tune but with the lower temp, will...

Alright guys, I found that Spectre makes a CAI for the 96-00 5.0 and 5.7. Here's the link to the one I'm looking at Spectre 9903. Quick question,...

well as i was leaving a freinds house in the blazer i got on it and pulled to 80-100 before i let out . thats when i noticed a misfire .i drove...

I got a 03 ecsb with a 5.3 that has a rough idle, and no ecu code. It only does it while I'm in drive with the brake on. I was thinking maybe a...

im not too sure how to explain the noise.But ill give it a try.it sounds like evry other spin the wheels make it does it.it sounds like its coming...

My trans blew on my 04 sierra friday and a friend of mine has a good low mile 4l60 with upgrades from an 02 z28. Will it work? will the electrical...

Well i have the MTI X1 cam in my truck the specs are 232,228 595/572@112 well i have full bolt on besides the underdrive pulley. I also have a 2600...

hey guys i remounted my tailshaft bushing this morning and seems to be fine i need to know what is the correct type of gasket maker to put between...

Hey guys i have a bit of a problem and need help. on my engines passanger side valve cover i have open breather drivers side i have a cut out pcv so...

while putting on my headers we dissasembled the intermediate shaft for better clearance and something seemed to spin loose. After everything was...

I am just trying to find what the 10 bolt axle length is on an 02 chevy. Moser claims not to know and I do not want to tear apart my rear end until I...

I dont know much I dont know what do do, dont have much money at all! what do I do? how much is this stuff? my truck's "Service Engine...

well i just fiished putting headers on the 86 silverado and building a y pipe and instaling a highflow cat. i also put in new plugs gapped correctly...

Hey just picked up some 241 heads and am going to install them on my 5.3L. I know they are going to lower my compression. Was just wondering how much...

I currently have a custom 3" mandrel bent catback with flowmaster 40 series si/so. It sounds good, but isn't loud enough, and doesn't have any...

I need some suggestions about my exhaust problem. Yesterday I installed Pacesetter Long tubes and ORY.(I have a Corsa Sport Exhaust) Only to find...