+ Post New Thread
Page 122 of 356 FirstFirst ... 22 72 112 120 121 122 123 124 132 172 222 ... LastLast
Threads 2421 to 2440 of 7108

Forum: Powertrain

Engine | Transmission | Drive Axle | Chassis | Fuel

  1. LQ4/LS2 rod swapping

    I'm building a pretty much stock 6.0l with the exception of forged pistons. i don't plan on climbing too high in the hp range as this will be my...

    Started by molitor‎, 11-15-2009 11:18 AM
    • Replies: 9
    • Views: 13,579
    11-17-2009, 11:47 AM Go to last post
  2. Flange for Cat Back

    Anyone know the part number of a 3" flange that will bolt to the back of my stock converter? I got some 3" mandrel bends and a Dynomax race muffler,...

    Started by straightaxle‎, 11-17-2009 12:02 AM
    • Replies: 1
    • Views: 1,222
    11-17-2009, 08:29 AM Go to last post
  3. Loud noise coming from under the truck 07 sierra

    My 07 sierra nnbs has a weird but pretty loud noise when i am backing up its like a vibrating noise coming from the middle of the truck it sounds...

    Started by chadt256‎, 11-15-2009 02:40 PM
    • Replies: 7
    • Views: 3,745
    11-16-2009, 09:52 AM Go to last post
  4. Help picking transmission parts.

    I know there are a few dealership guys here good with transmissions. My transmission is slipping really bad and it is coming time to rebuild it. I...

    Started by yournamehere018‎, 11-15-2009 12:01 PM
    • Replies: 1
    • Views: 1,205
    11-15-2009, 12:09 PM Go to last post
  5. TC lock up switch???

    Can you put a TC lock switch on a 4l60E? i didnt know if you could or not

    Started by aballl18‎, 11-15-2009 12:56 AM
    • Replies: 0
    • Views: 1,205
    11-15-2009, 12:56 AM Go to last post
  6. LSx lifters

    can these lifters be put in backwards? the priming hole is only on one side and the oil passage is on the cylinder side of the block... if the...

    Started by johnathan‎, 11-14-2009 01:23 PM
    • Replies: 2
    • Views: 1,717
    11-14-2009, 10:55 PM Go to last post
  7. Servo question.

    Alright so in about the next week or so I plan on buying some vette servos and a transgo HD-2 shift kit my question is should I buy the billet 4th...

    Started by Jordan836‎, 11-10-2009 05:14 PM
    • Replies: 3
    • Views: 1,734
    11-14-2009, 10:45 PM Go to last post
  8. 2007 5.3 with 862 heads?

    So I have a friend who's got a 5.3 for sale supposedly out of a 2007 truck. I'm not sure were to look on the motor to know this for sure it has 862...

    Started by chevyfast‎, 11-09-2009 11:29 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 18,532
    11-14-2009, 08:14 PM Go to last post
  9. Annonying noise and trans leak?

    so lately there has been this GAWD AWFUL squeeking noise that has been comin from my truck, i know it's not the engine so it has to be something with...

    Started by jetersaurous‎, 11-05-2009 10:00 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 4,009
    11-14-2009, 07:58 PM Go to last post
  10. Most Effective Upgrades

    What do you think the most effective upgrades for trucks and suv's are? let the discussion begin

    Started by ninjawhiteboy12‎, 10-24-2009 05:32 PM
    8 Pages
    1 2 3 ... 8
    • Replies: 70
    • Views: 12,068
    11-14-2009, 03:11 PM Go to last post
  11. fule pressure

    installed a high volume pump with hot wire set up on a 99 ta and i am running a ls3 set from a vette but my fule pressure is over 100psi and and...

    Started by orly‎, 11-10-2009 07:46 PM
    • Replies: 4
    • Views: 1,863
    11-14-2009, 01:34 PM Go to last post
  12. 410's choice..

    I looking to get a set of gears and I was wondering if anyone is running the GM 410's or 411's from Ron's Machine shop on ebay? Are these gears...

    Started by Robt34‎, 11-12-2009 11:42 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 3,606
    11-14-2009, 11:52 AM Go to last post
  13. L92 Swap On A 6.0. Who Has Done It?

    I'm looking at putting a set of L92 heads with 918 springs on my 05 6.0. plan on using 07 escalade intake and 90 mm throttle body with torque rush...

    Started by MEANGENE75‎, 10-28-2009 05:42 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 35
    • Views: 9,251
    11-13-2009, 10:13 AM Go to last post
  14. Hitching

    Cruising down the road on a day with any moisture in the air at a steady speed truck hitches and check engine light trips. Replaced plugs, wires, and...

    Started by 97GMC97‎, 11-12-2009 05:25 PM
    • Replies: 3
    • Views: 1,400
    11-12-2009, 08:13 PM Go to last post
  15. Engine Porn

    This Is The 402 I Built For My 69 Camaro New 6.0 Block Eagle Crank And Rods Manley L92 Pistons L92 Heads 918 Springs L76 Intake, 90 Mm T.b....

    Started by MEANGENE75‎, 10-28-2009 06:15 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 6,914
    11-12-2009, 08:06 AM Go to last post
  16. Need fuel system advice.

    My truck being a 4.3 has a return line, my '05 5.3 does not. Since it's got the square fuel rails that are supposedly the cats ass I don't really...

    Started by Frenchy‎, 11-11-2009 08:42 PM
    • Replies: 1
    • Views: 1,214
    11-12-2009, 03:10 AM Go to last post
  17. wiring help

    ok i kno i posted this in the wrong section. i did it on purpose as this one gets more traffic. I need to know which wire is the signal wire in the...

    Started by SNEEKY‎, 11-10-2009 07:07 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 2,872
    11-12-2009, 02:54 AM Go to last post
  18. Question about fuel cell

    Well i just installed a new aluminum fuel cell and in-line fuel pump in my 2004 gmc sierra. I bypassed the emmisions stuff to make the install more...

    Started by ccd_1606‎, 10-29-2009 11:31 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 3,349
    11-11-2009, 06:58 PM Go to last post
  19. Thumbs up ChevyLee's 4link

    Teaser pics for Mic... Clean frame hehe Jon and I started Monday, Jeff (firefighter) showed up and helped out too for a while, thanks. Also...

    Started by ChevyLee‎, 01-07-2009 10:43 PM
    11 Pages
    1 2 3 ... 11
    • Replies: 101
    • Views: 18,346
    11-11-2009, 06:08 PM Go to last post
  20. Bumper Fix

    Hey guys wasn't quit sure where to post this... My truck at some point in its life was in a pretty good wreck enough for the driverside frame rail to...

    Started by Chevy96‎, 11-10-2009 04:05 PM
    • Replies: 3
    • Views: 1,595
    11-10-2009, 09:23 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts