All LS Based Conversions
I have a 87 blazer tank with the ep241? Fuel pump on my sending unit. My question is how much room should I have between the sock on the bottom and...
Ive been meaning to put up pics of the build and have just now got the pics off the camera.
If I was to put a sanden 508 compressor into my truck, replacing the r4, how do I get the hoses? Is there anyone who sells sanden hoses on one end...
a guy i know came to me trying to sell a 6.0 all aluminum with 4l80e ecm harness radiator drive shaft cats, and all with under 80k. I had to work...
Got working on my truck finally today. Was having clutch and starter clearance issues. First setup was a LS6 flywheel/4.8 clutch/NV3500. Bolted up,...
can i leave my stock ecm to control my transmission 99 4l80e
Got my blazer started up. There are 3 wires i need to hook up on my np harness. A blue,green,and a white. Also where do i need to land my brake...
Well went and picked up truck at the exhaust shop today. went to drive it home but the tranny is stuck in limp mod....... its a 93 chev dually with a...
I have searched and read over and over but am confused about these crankshaft spacers. I am bolting a 2002 6.0 with a flat flexplate to a 700r4 can i...
What radiator hoses is everyone running on lq4 to obs swap. I need a throttle cable bracket since i went from dbw to dbc. What is the consensus...
Hey guys, I've got a 1986 C10 that I'm looking to swap a 5.3L into. It currently has a 700R4 which I am going to keep, and I want to mate the 5.3L to...
anyone know where i can find the speedometer wire for the cluster? is it on the c100 firewall plug?
Ive done a swap from a 1992 TBI 350 to a 2005 LM7. Everything works perfectly, except the AC. Im using the factory AC system with a bracket and...
ok my engine came to me missing a few sensors apparently. the two red caps are the ones im looking for.one is on top of the intake just behind the...
What all dose it take to do a 5.3 swap in thease year trucks?
Getting my fuel system prepared, and was wondering if the flex hoses that attach to the tank sending unit (1990 obs) will handle the 58psi needed for...
As much as I wish it were possible,my 1998 K1500 5.7 to 6.0 swap seems to be filling the tank as I drive!All other guages appear to be reading...
ok heres the low down. 95 chevy tbi being swapped to 2002 6.0 from a yukon denali. i have a nelson harness and ecm. my questions are.... 1 the...
do any one now or have the pinouts for 09 ctsv need to compare to my gmpp harness
as title says, 5.3 vs 6.0L,, runs great, no problems. mine is(i'm told) a 6.0L 2008 2500HD, 317# heads,iron block,, 4L80E trans. question;...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
