All LS Based Conversions
To command the PCM to enable a/c idle tables when the clutch cycles to on? 04 PCM with LQ4. Idle was still somewhat stable during clutch cycle after...
Do you that have finished the OBS swap care to post up what you did for an air intake?? How far does the maf meter need to be from the throttle body??
Hi all, I need to know where to cut and box the frame on my 92 4X4, in order to have clearance for my AC compressor. It's a 6.0, out of an '04...
hello i got a question i was wondering if it was possible to cut my existing stock tbi braided lines and add some ans fittings to some quick...
anyone willing to let me use their balancer intaller tool in the dfw area, willing to give a 12 pack:beerchug:
My new project....as if I needed a new one. With this swap, I'll have my weight over the rearend and also with the new shock setup it will ride alot...
Recently put a 2002 5.3 in my 86 K5. Runs great and i love it. Got ac working now but vents are stuck due to no vacumn source. What's wrong with...
I am in the process of swapping my tired old 350 and 700R4 for a LQ4 and T56 in my 1991 Chevy C1500 reg cab step side bed pickup. I am using a set of...
Anyone seen this? Ugly as can be. I have always thought a 454SS build would be awesome, but these guys got it largely wrong IMO. :sadnana: ...
I lowered my truck after the swap, I thought after the swap with the stock suspension on it that it sat higher in the front that it did with the 4.3...
are you guys running the new wire all the way to the pump or using the existing, can i just connect it to the fuel pump 12v wire at the stock relay...
Fired my swap up last night, 2 thumbs up to Jon at nelson performance!! My linkage has issues, the part that runs from the frame to trans is too...
I'm considering doing a 5.3 swap on my 2000 silverado ecsb with a 4.3 and a 5 speed. I've found an engine that's somewhat local but it's out of a...
Can I remove the round coffee can evap canister under the hood or remove it and plug off the line going to the tank?
Anyone have trouble with the throttle sticking? Its not the cable, ill stop and open the hood and theres slack on my obs just finished the swap
My driveshaft fits, but its clearance in the transfercase is too close for comfort. When I am in the dunes I dont want it to preload and jam itself...
Whats the safest and best option to run my feed and return lines, The lines and exhaust are all I neeed to have this swap ready. I just want to make...
i have an L33 engine that i am unsure if it is a single or dual fuel lines. There are two tan colored lines that run down the back of the engine and...
Im looking for PCM printouts for a 2003 express 6.0. I can't seem to locate any that match my harness. Does anyone have these or know where I could...
I am about to undergo my first LS swap. I picked up a Very Very clean 96 3/4 ton 2 wheel drive Suburban for $900. It has a blown head gasket but a...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules