Forum: LSX Truck Conversions

My engine is in. I would like opinions on my rake. From the top of the engine it is a 7 degrees. AA says between 3 - 5. Would 7 degrees make a...

i need some advice the yukon engine had all the wiring cut off i've seen some sites that sell wiring harness but not specific for a 04 yukon does any...

do any of yall know where I can find motor mounts to install an ls1 out of a 1999 trans am into a 90 chevy 1500 2wd or do I have to make them. what...

Story: Drove the truck a few times, ran good. The last two times, while driving it, it would just totaly, instantley, shut off. Like an instant fuel...

Just wondering I can get one with no accessories for 1000 but i can get a Complete one with comp. for 1800 with harness. and its still in the trk...

Here are some pictures of my recently completed swap:

Im in the market for a new truck, mainly performance. I was wondering if the top end of a LS2 would work on the 6.0 Vortec?

I am installing a 2001 5.3 Vortec engine into my Landcruiser. This engine is a drive by wire. My question is, From plug C100, some of these wires...

I am in the middle of converting the factory harness on my 2000 5.3l/4l60e and want to make sure of what all I can safely remove. 1. EGR 2. Evap....

Does the PCM need the speedometer signal to run a 4L80-E properly?

Got the comp. from Allen today. Started cranking and figured out the injectors were gummed up a little. Had the father in law crank it while I tapped...

eBay Motors: 93-97 LT1 LS1 Camaro Corvette Fuel Rail 6 AN Fittings (item 220158497158 end time Oct-15-07 14:27:04 PDT) Will these fit a 2000 5.3l...

I got my sending unit and pump in today. There was a rubber bushing that looked to go on the sending unit where the pump rest but i couldnt get the...

I need a bowtie for the grill on the 86 Silverado GM part # 14043882. Its a 4 headlight truck. GM discontinued them in 2000. Everything else is...

I've found an l92 with accessories, ecm, harness, and 6l80e tranny with transfercase and I want to put in in my truck. What am I getting myself into...

Anyone have any experience with using the stock fuse block and harness on your swap? It is cheaper for me to tap my truck into the new fuse block...

I may have stumbled across a new 5.3L to replace the one I got screwed out of last time (long story). Anyways, if I wind up buying it, I want to...

Is it possible to disable vats with resistors? If so, can someone please tell me how. Thanks.

My 408 is finally ready so I am having it put in to replace the 5.3. Is there anything that I need to do or modify in order to do this swap? Also, I...

Hi I have 6.0 engine out 2001 crew cab silverado 3500, VIN 1gcjc33u21f174906, my question is; It model has passlock ? Raùl