Forum: LSX Truck Conversions

what will i need to make this work ???? want to keep the SFI

Its time for radiator hoses for the 86. Does anybody know part #'s that will work? I'm running the factory radiator that came with the diesel. I hope...

I have been reading as many threads as I can find about swapping the F-body LS1 into a '91 C1500. I also checked some links to sales on eBay. It...

I apologize for my lack of experience, but I am learning all the lingo and jargon for this site. I'm just full of questions tonight. Does "OBS"...

just a little vid my truck is dirty though YouTube - lebanon mo joshes s-10 walk around

Just finished a build on my 99 ext. cab. We installed a LS6, custom camshaft, Dynatech headers, Yank 3400 converter, Rhino79 tune, and lots more....

Hi everyone im new to the site I know there is a place to introduce myself but this should do fine. I have a 2006 reg. cab 6 foot bed 2wd with a...

what all will i need to use the intake on the vortec??? want to keep the SFI.

Hi everyone im new to the forum, but not to silverados! Well i have a 2006 silverado rcsb 2wd with a 5.3. I have a whipple supercharger on it...

ok first off I would like to know what kind of gas mileage will I get in everyday driving at a top speed of 70 mph, I commute. I bought a 6.0 lq4 all...

I have tremec T-56 from a 99 camaro, I would like to know if it will bolt up to a 92 silverado 5.7. It has the original 5 speed with 192,000 on it....

I'll be working on a 98 chevy vortec 4.3 truck. I have a 5.3 (cable TB)/tranny/harness/pcm. Converting the harness to be standalone is fairly...

Guys I need some help. I can’t figure this one out. 2001 Yukon 5.3 70,000 miles. We have owned it since 2002. You try to crank it up and no start....

So finally picked it up 02' 6.0 out of a Denali trk with 65k, so here goes the ?'s. I have poured throught this site looking for answers and just...

I'm installing a 4L80-E into my 1989 K-1500 and I have run into a problem. I want to use the stock column shifter with the new transmission. Has...

does anybody have any info on these new 799 casting number they said it was a good head for a swap.:hyper2:

My engine is in. I would like opinions on my rake. From the top of the engine it is a 7 degrees. AA says between 3 - 5. Would 7 degrees make a...

i need some advice the yukon engine had all the wiring cut off i've seen some sites that sell wiring harness but not specific for a 04 yukon does any...

do any of yall know where I can find motor mounts to install an ls1 out of a 1999 trans am into a 90 chevy 1500 2wd or do I have to make them. what...