Forum: LSX Truck Conversions

In looking for an engine/trans combo for my swap, im coming up kinda short on 6.0/80e setups. I was wondering, would an older model 80e be just...

I started getting my motor ready to pull today and am wondering how much attention I need to pay to my old harness? I plan on getting someone to...

I know asking a lot of questions today. But I hear you need a fly wheel spacer if you ahve a 97 4l60e. would you still need one if you got a...

Hey guys, I've searched and didn't find much. I want to do the 6.0 swap, but i want to know how much this will hurt my mpg. I get about 13 city...

lets see how every one mounted there PCM under hood of a truck that never had one

I am about to acquire a 89 RCSB silverado. I has no motor/trans etc. Just a rolling body and interior. I am wanting to do a 5.3 swap. Which 5.3...

I have built my harness form schematics found on the internet and all fans a functioning perfectly when relay wires are grounded. My question is,...

Couldn't find any info on an easy way to do it, or pics of anyone elses mounts, so Here is my setup, on a 28" radiator. Fan (I think it's mounted...

What my plans are is to get a Diesel truck front bumper with the intake air holes in the bumper and have my air intake run to it. What I would do...

started taking it apart today not to bad a for a few hours should have the 4.3 out by Thanks giving. Well guys heres the progess...

I've searched and not found much info on getting the a/c to fit and work properly. I have a 03 5.3 going into 96. I've heard that I may need to...

I always thought the ls engine used a different fuel pump than the 96-up. According to our "sticky" on the swap it says anything pre 96 would need...

Just saw this! eBay Motors: Chevrolet : Other Pickups (item 110271165414 end time Aug-05-08 13:34:29 PDT)

the tuning is great now and i appreciate you guys advice on the afr! one last thing though i have a question about and that would be the idle. in...

does anybody know a good place to buy dbw parts my local junkyards have proved useless

just got done fine tuning on the dyno "i think"? the fuel air ratio is dead at 13.01 throughout the entire rpm range. could it be leaned any more...

ok so here is the problem this time. i decided to put in the 4L80E which came with the motor i have the 2004 LQ4 instead of using the turbo 350 which...

I am getting ready to do my 6.0/4L80 swap in my 1990 2WD truck, can i use the truck oil pan? and if so how far below my Xmember will it set? I am...

I've searched and found the cable needed if I was using the Drive by cable but what all is needed to keep cruise control with a drive by wire setup?

in tryin to get my budget together for my 5.3 and/or 6.0 swap, im wondering what ya'll as running for exhaust setup? i would like to do it right the...