Forum: LSX Truck Conversions

would a need the harness or computer for the 6.0 or can i keep my old one a get a tune?

I have a 95 c1500 I have done the ls1 t56 swap now my ? is can I use the gouges out of a 02 vette In a custom dash I am building for the truck is it...

Recently did a 5.3 4L60 swap in my 72 and would love some long tubes. Anyone know who makes them?

Yes I am new here :D , but as some of you may know, I will be installing a 2008 5.3 into my '72 Blazer. I will be picking up the motor this weekend....

i have a 90 jeep cherokee. i plan to put an lt1 in it. i have already bought a 94 NP241 out of a Silverodo, 97 4L60E out of a S10 Blazer. my...

What's up guys I've got a few pics of my friends procharged 6.0 swap in his 92 chevy. Let me know wat u think. The pics r on my myspace page under...

I am swapping a LQ4 into a 94 Chevy truck and wanted to know what you guys do with that little 3/8" coolant line that goes from the driverside head...

I'm finishing up a 6.0L/4L80E swap into my '88 RCSB and have a few wires I'm not 100 % sure on what they are. I need a schematic that shows all the...

how much of a headache is it to rework a harness to be a stand alone harness? i am in the process of putting a 6.0/4l80 in my 83 swb cheby, and dont...

so the swap is a 83 c10, 6.0/80e going in. what radiator should i go with? if i was able to use the original rad. what would i do with the steam...

Trying to fit my truck with braided stainless tranny cooler lines. Any one know what thread the feed and return ports are in trans case? Local...

im putting a 2004 GTO engine in my 2002 silverado with a 4.8L. the i bought the motor and trans ie t-56 6 speed and my truck has an automatic, my...

my Tahoe conversion is getting a little shape these days. The engine is still in a container somewhere on the Atlantic... but I have enough other...

Has anyone heard or put a 4.00 stroke crank in a 5.3 to get a 359 or a 5.3 bored .030 over with a 4.00 crank and have a 365. I think you will get...

Would shifting issues from 1-2 be caused by a bad torque converter? Does it primarily at low rpms. Tranny fluid smells a little burnt, but no metal...

I have a 85 Silverado that is my daily, and im thinking about doing a 5.3/4L60e swap. I was just wondering how much you guys who have done the swap...

i was woundering if i were to swap a 6.0 in place of my 5.3 could i use the 5.3 wiring harness and computer. thanks any help would be great

Anyone seen this block from World Products? Its a GenI SBC that uses LS heads and valvetrain... 427 cube SB/LS hybrid check it out Motown LS...